Llink:nmt

nmt llink binaries

This binary works for the NMT Popcorn Hour A-100 unit, it may work on other NMT units as well.

Basic installation

There are three (3) files needed for installation on the NetworkMediaTank. But the good news is that it requires no difficult instructions.

Installing to hard disk

Download all three files:

llink-installer.html llink-installer.html 15/08/2008
llink-installer.cgi llink-installer.cgi 15/08/2008
llink-2.0.8-nmt.zip

and upload them to your nmt most easily your HDD. You could also use a USB stick, place the files in the root of the stick.

You must also make llink-installer.cgi be executable.

site chmod 755 llink-installer.cgi

Push "Sources" to get your to your nmt start page
Select "HARD_DISK" (or USB stick if you chose that)
Select "Files" (Forth icon on the right. Video, Music, Photos, Files)
Pick "llink-installer.html".
Select "Install to HARD_DISK" - if this fails, you did not make llink-installer.cgi executable
If all goes well, you can now push "Sources" and find "llink-nmt" as a new option.

Running from USB stick

Download all three files:

llink-installer.html
llink-installer.cgi
llink-2.0.8-nmt.tar.gz

Untar the llink-2.0.8-nmt.tar.gz to the root of your USB stick. This should create a directory called llink at the root level. Copy the other two files over. Your USB stick should have:

/llink-installer.html
/llink-installer.cgi
/llink/
/llink/llink
/llink/llink.conf
/llink/skin/

etc. The remaining files are not shown.

You must also make llink-installer.cgi be executable.

Push "Sources" to get your to your nmt start page
Select "USB_DRIVE_A" (or USB_DRIVE_A-1, etc as appropriate)
Select "Files" (Forth icon on the right. Video, Music, Photos, Files)
Pick "llink-installer.html".
Select "Run from USB_DRIVE_A" if this fails, you did not make llink-installer.cgi executable
If all goes well, you can now push "Sources" and find "llink-nmt" as a new option.

Older binaries:

 llink-2.0.1-nmt.tar.gz