Llink:synology

Synology NAS

The Synology NAS can host the llink server. It has been reported successfully installed on a CS-406, firmware 518. The CS-406 has a PPC-based cpu which indicates that all Synology DS and RS NAS in the x06-series should be able to run the compiled binary below.

If you use a Synology NAS from the x07-series there is a toolchain available for compiling source at Synology.com [1]

Binaries:

llink-1.9.2-synology.tar.gz

Installation pre-requisites

Telnet/SSH-patch installed on the NAS.

If you want to autostart llink from boot, you can use this script.

To-do/wishlist

In no special order

• Make ipkg package
• Investigate possible network interference with SSODS/Slimserver
• Change defaults in llink.conf to match Synology default setup
• Compile binary for x07-series (Marvel based chip)
  

Additional resources and references

NSLU2-Linux.org [2]
flipflip's Diskstation site [3]
Synology's official forum [4]