Llink:synology: Difference between revisions
mNo edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
== Synology NAS == | == Synology NAS == | ||
The Synology NAS can host the [[llink]] server. It has been reported successfully installed on a CS-406, firmware 518. | The Synology NAS can host the [[llink]] server. It has been reported successfully installed on a CS-406, firmware 518 and 590. | ||
The CS-406 has a PPC-based cpu which indicates that all Synology DS and RS NAS in the x06-series should be able to run the compiled binary below. | The CS-406 has a PPC-based cpu which indicates that all Synology DS and RS NAS in the x06-series should be able to run the compiled binary below. | ||
If you use a Synology NAS from the x07-series there is a toolchain available for compiling source | If you use a Synology NAS from the x07-series there is a toolchain available for compiling source at [http://www.synology.com/wiki/index.php/Mods_for_Marvell_mv5281_ARM-based_Synology_Products#Toolchain Synology.com] | ||
Binaries: | Binaries: | ||
| Line 15: | Line 15: | ||
Telnet/SSH-patch installed on the NAS. | Telnet/SSH-patch installed on the NAS. | ||
If you want to autostart llink from boot, you can use this [[Llink:synology_autostart|script]]. | If you want to autostart llink from boot, you can use this [[Llink:synology_autostart|script]].<br> | ||
Otherwise you must enter via telnet and start manually after shutdown or restart. | |||
=== To-do/wishlist === | === To-do/wishlist === | ||
Revision as of 00:27, 29 March 2008
Synology NAS
The Synology NAS can host the llink server. It has been reported successfully installed on a CS-406, firmware 518 and 590. The CS-406 has a PPC-based cpu which indicates that all Synology DS and RS NAS in the x06-series should be able to run the compiled binary below.
If you use a Synology NAS from the x07-series there is a toolchain available for compiling source at Synology.com
Binaries:
llink-1.9.2-synology.tar.gz
Once you've installed the binary you have to update the llink.conf file so it points to your media files, uses the right port etc.
Installation pre-requisites
Telnet/SSH-patch installed on the NAS.
If you want to autostart llink from boot, you can use this script.
Otherwise you must enter via telnet and start manually after shutdown or restart.
To-do/wishlist
In no special order
- Compile binary for x07-series (Marvell based chip)
- Verify how the jukebox skin performs
Additional resources and references
NSLU2-Linux.org [1]
flipflip's Diskstation site [2]
Synology's official forum [3]