Llink:synology: Difference between revisions
No edit summary |
mNo edit summary |
||
| Line 13: | Line 13: | ||
Telnet/SSH-patch installed on the NAS. | Telnet/SSH-patch installed on the NAS. | ||
If you want to autostart llink from boot, you can use this [[Llink:synology_autostart|script]]. | |||
=== To-do/wishlist === | === To-do/wishlist === | ||
Revision as of 11:07, 20 February 2008
Synology NAS
The Synology NAS can host the llink server. It has been reported successfully installed on a CS-406, firmware 518. The CS-406 has a PPC-based cpu which indicates that all Synology DS and RS NAS in the x06-series should be able to run the compiled binary below.
Binaries:
llink-1.9.2-synology.tar.gz
Installation pre-requisites
Telnet/SSH-patch installed on the NAS.
If you want to autostart llink from boot, you can use this script.
To-do/wishlist
In no special order
- Make ipkg package
- Configure startup scripts
- Investigate possible network interference with SSODS/Slimserver
- Change defaults in llink.conf to match Synology default setup
- Compile binary for x07-series (Marvel based chip)
Additional resources and references
NSLU2-Linux.org [1]
flipflip's Diskstation site [2]
Synology's official forum [3]